Electrical work
Electricity is the most important step in creating comfortable housing. Nowadays everything depends on electricity - computers, lamps, household appliances and so on. To work correctly, you need to properly work on electrical installation. This process will not affect errors, because they can cause catastrophic results.
Types of electric installation
If the apartment has been for many years, then changing the electrical wiring is not whim, but the necessity. Electricity lines in such buildings are not intended for high power, which provides modern household appliances.
There are several types of electrical work.
The first type is installation and replacement of electricity metering equipment.
The second type is the installation of new power stations.
The third type is the installation of sockets and concentrations.
The fourth type is light bulb.
The fifth type is the diagnosis of the electrical system.
Sixth type is a household appliances union.
On the stages of works
Now let's talk about what steps you can take in the process of electric work.
In the first stage the dismantling and marking begins. Dismantle removes old electrical lines. First you need to disconnect them from the highway. Next is the marking. This process involves marking the scheme. Thanks to this you can install the equipment correctly. Without marking, you will not be able to properly cables etc. In addition, you must coordinate all electrical work in sewage and other communication plans.
The second stage is strobing and wiring. Punch for such a job. With him you will need the hearts of the channels on the walls. They are calculated lines. This process The walls should be resurrected. Otherwise they may be cracked. Cables are formed in boxes and plastered in plaster. For high power it is necessary to take additional cable. It is also necessary to install automatic concentrates. They start with a short circuit.
The third stage concerns equipment, wiring and network inspection. Sockets and switches are fixed in the plaster solution, so as not to occur. Concentrators are installed between phase cable faults and sockets installed on the surface. All electrical devices are located in the available location. Wires are disconnected using special terminals. After that you need to make sure that everything is done quality and without mistakes.
The final stage is the system startup and correction. In no case do not immediately install the device without checking the entire electrical system.
You can order electronic works in our company. From our side, we promise that the work will be done on a timely and high level.
Job description | Unit | price, LARI | Quantity | Price |
ელეკტრო გაყვანილობის მონტაჟი | Point | 22.00 | ||
installation of electrical panels | Piece | 70.00 | ||
Installation of circuit breakers | Piece | 22.00 |